Table of Contents
CHANNEL <1A> for the balance channel located nearest
the plane of the propeller with the notation "PROP
CHAN"
After the user has set the aircraft ID and channels, as desired,
press
START
Enter channel assignment information, using the first Propeller
Balance Setup screen that displays.
NOTE: The user may change the channel assignments by
pressing the appropriate context key, if the installation for
the subject aircraft is different from the default settings.
This action allows the user to select the user's own channel
assignments.
After the user makes sure the channel assignments shown on the
Propeller Balance Setup screen are the same as the actual
channels used, press
CAUTION: We suggest that the user perform a check run,
both on the first run and after the front balance channel is
within limits. If the rear channel is higher than the original
reading after the propeller is balanced, further testing is
necessary to find out the possible cause. The problem could
be a propeller out of track or an imbalance in the power
train rotating components (crank shaft). Do not balance
under this type of condition. Select channels 2A for a rear
check Velocimeter, if the user is using one.
5.4.1.3
Press
START.
unit for the propeller being balanced. Since high horsepower
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
to continue with the propeller setup operation.
to advance to the next screen.
START
Entering Horsepower
Use the
HP ENGINE
13841 Rev A
Chapter 5 – General Operation
context key to set the Vibrex
101
Chapters
Table of Contents
