System Repair; Diagnostic Messages; Card Removal And Installation; Model 4010 Programming Cable Wiring Diagram - ZETRON 4010 Service Manual
Radio dispatch console
Hide thumbs
Also See for 4010:
- Installation and programming (138 pages) ,
- Spec sheet (4 pages) ,
- Programming manual (117 pages)
Table of Contents
SYSTEM REPAIR
DIAGNOSTIC MESSAGES
If the console's continuous system diagnostics finds a problem, the console LCD will display a diag-
nostic message indicating the general nature of the problem. The following table shows the various
diagnostics messages and their meanings.
Message
An internal error has occurred on the console. The "nnn" is a three digit, decimal number
THX nnn
that the factory can use to help isolate the condition. Be sure to record this number. This
condition does not usually prevent normal operation.
The programmed channel configuration of the console does not match the channel cards in
CardErr
the console. Channels that are affected will not operate until the problem is corrected.
The Model 4010 CPS configuration data has been corrupted or was never initialized.
CPSdataErr
Reprogram the Model 4010. Refer to the Model 4010 Programming Manual (Part No. 025-
9229) for more information.
CARD REMOVAL AND INSTALLATION
To remove and install the Dual Channel Card and other removable option cards, follow the steps
below:
1. Disconnect power.
2. Open the console by unscrewing the two latches on the back of the console and lifting the top
open.
Caution
Keep the front of the unit on the top of the table; do not let the front hang over the table
edge. The console can easily be knocked off balance onto the floor when the front hangs
off the table.
3. To remove a card, unscrew the single mounting screw on the rear of the console and rock and
lift the card up and away from the back of the unit.
4. To install a card, insert the side away from the back panel in first, then rock the card towards
the back panel into position. Take care that the LEDs get properly positioned. Secure the card
by inserting the screw through the hole in the back panel into the bracket on the card.
5. Close the console and tighten the two latches on the back of the unit.
6. Connect to power; the configuration changes are sensed on power up.
Meaning
Model 4010 Radio Dispatch Console Service Manual
MODEL 4010 PROGRAMMING CABLE WIRING DIAGRAM
SERVICE DIAGRAMS
The remainder of this manual is devoted to the various PCB parts lists, schematics, component silk-
screens, and assembly drawings that apply to the Model 4010 and Model 4115 consoles.
15
- Quick Links:
- Model 4010
- Block Diagram
Hide quick links:
Table of Contents
