Table of Contents
9C-79 Instrumentation / Driver Info. / Horn:
3. If J 42059 tool fails to release the lighter socket from
the retainer, perform the following alternate method:
a. Insert a small grinding tool with a cutoff wheel
into the socket.
b. Remove the plastic latches in the 3 mm (0.11 in)
square windows.
c. Use the J 42059 as directed above to remove
the socket.
Fastener Tightening Specifications - Instrument Panel and Console Trim
Instrument Panel Center Lower Trim Panel Assembly Screws
Instrument Panel Compartment Screws
Instrument Panel Compartment Door Screws
Instrument Panel Compartment Latch Screws
Instrument Panel Insulator/Closeout Panel- right
Instrument Panel Lower Trim Panel Screws
Instrument Panel Lower Left Trim Panel Assembly Screws
Instrument Panel Lower Trim Panel Assembly Screws
Instrument Panel Knee Bolster Screw
Instrument Panel Knee Bolster Reinforcement Screw
Instrument Panel Retainer Assembly Bolts
Instrument Panel Retainer Assembly Nuts
Instrument Panel Tie Bar to Body Bolts
Instrument Panel Tie Bar to HVAC Module Assembly Bolts
Instrument Panel Tie Bar to HVAC Module Assembly Nuts
Instrument Panel Upper Trim Panel Bolts
Instrument Panel Upper Trim Panel Screws
Specifications
Application
Installation Procedure
1. Route the connector through the retainer. Align the
accessory power receptacle retainer to the slot in the
opening.
2. Install the retainer by pressing into place fully
seated.
3. Connect the electrical connector to the receptacle.
4. Align the tabs on the receptacle to the slots in the
retainer. Install the accessory power receptacle by
pressing into place until fully seated.
5. Install the accessory power receptacle fuse.
Specification
Metric
2 N⋅m
2 N⋅m
2 N⋅m
2 N⋅m
2 N⋅m
2 N⋅m
2 N⋅m
2 N⋅m
2 N⋅m
2 N⋅m
9 N⋅m
9 N⋅m
25 N⋅m
4 N⋅m
4 N⋅m
3 N⋅m
2 N⋅m
English
18 lb in
18 lb in
18 lb in
18 lb in
18 lb in
18 lb in
18 lb in
18 lb in
18 lb in
18 lb in
80 lb in
80 lb in
18 lb ft
36 lb in
36 lb in
27 lb in
18 lb in
Table of Contents
Troubleshooting
