Table of Contents
6A-56 ENGINE MECHANICAL
(A)-3. Driver handle
1) Set connecting rod (3) to piston (1).
Crankshaft pulley side
2. Front
2) Fit piston pin (2) to piston (3) and connecting rod (4).
1. Hole
5. Front mark
(A)-1. Base
(A)-2. Base cap
(A)-3. Driver handle
(A)-4. Guide
(A)-6. Spring
(A)-7. Spring guide
After applying engine oil to piston pin holes in piston and con-
necting rod, fit connecting rod to piston as shown in figure.
Oil hole (4) should be come on intake side.
a) Place piston onto special tool (Piston in remover and install-
er) as shown in figure.
Special Tool
(A): 09910-38211
b) Press piston pin (3) into connecting rod until line (1) marked
on driver handle is flush with flat surface of piston (2).
- Quick Links:
- English
Hide quick links:
Chapters
Table of Contents
