Table of Contents
Engine Assembly
REMOVAL
1) Release fuel pressure in fuel feed line by referring to Section
6 of the Service Manual mentioned in the FOREWORD of
this manual.
2) After disconnect negative and positive cables at battery,
remove battery and battery tray.
3) Remove engine hood after disconnecting windshield washer
hose.
4) Drain cooling system.
WARNING:
To help avoid danger of being burned, do not remove
drain plug and radiator cap while engine and radiator are
still hot. Scalding fluid and steam can be blown out under
pressure if plug and cap are taken off too soon.
5) Disconnect radiator inlet hose from thermostat case and out-
let hose from water inlet pipe.
6) Remove air cleaner outlet No.1 hose (1) and No.2 hose (2)
with air intake joint (3).
7) Remove suction pipe (5) and remove air cleaner assembly
(4) by removing its fastening bolt (6).
8) Disconnect the following cables.
• Accelerator cable (1) from throttle body (2).
• Clutch cable from transmission.
• Gear shift and select control cables from transmission.
9) Disconnect the following vacuum hose.
• Brake booster hose (1) from intake manifold.
• Canister purge hose (2) from EVAP canister purge valve.
ENGINE MECHANICAL 6A1-3
- Quick Links:
- English
Hide quick links:
Chapters
Table of Contents
