To Install The Condensate Trap - Daikin Altherma EHY2KOMB28AA Installation And Operation Manual
Hybrid monobloc – gas boiler module
Hide thumbs
Also See for Altherma EHY2KOMB28AA:
- User reference manual (28 pages) ,
- Installer's reference manual (112 pages)
Table of Contents
6 Installation
2 The bracket to mount the boiler on the heat pump module is an
accessory of the gasboiler. Fix the wall bracket to the wall with
2 M8 bolts.
2×
3 Lift the boiler. One person lifts the gas boiler on the left side (left
hand on the top and right hand on the bottom) and another
person lifts the gas boiler on the right side (left hand on the
bottom and right hand on the top).
4 Tilt the top of the unit at the position of the wall bracket and
slide the boiler downwards to fix the boiler bracket onto the wall
bracket.
5 Make sure the gas boiler is fixed properly to the wall.
Installation and operation manual
12
33~36kg
6.3.2
To install the condensate trap
INFORMATION
The boiler is provided with a Ø25 mm flexible pipe on the
condensate trap.
Prerequisite: The boiler MUST be opened before installing the
condensate trap.
1 Fit the flexible tube (accessory) to the condensate trap outlet.
2 Fill the condensate trap with water.
3 Slide the condensate trap as far as possible upwards onto the
condensate drain connector below the gas boiler.
4 Connect the flexible tube (where applicable with the overflow
pipe from the pressure relief valve) to the drain via an open
connection.
WARNING
▪ ALWAYS fill the condensate trap with water and place
it on the boiler before powering up the boiler. See
illustration below.
▪ NOT placing or filling up the condensate trap may
cause flue gases to come into the installation room and
can lead to dangerous situations!
▪ In order to place the condensate trap, the front cover
MUST be pulled forward or removed entirely.
Daikin Altherma hybrid monobloc – Gas boiler module
EHY2KOMB28+32AA
4P538953-1 – 2018.06
- Quick Links:
- About the Product
Hide quick links:
Table of Contents
