Toshiba G3 Instruction Manual page 22
Unified controller, i/o adapter module
Hide thumbs
Also See for G3:
- Specification (4 pages) ,
- Application manualline (2 pages) ,
- Operation manual addendum (30 pages)
Table of Contents
Chapter 1 Introducing GA932 Module
■ Operation mode setting switch (MODE)
MODE is the switch for setting the operation mode. Please use this switch all
OFF. For details, refer to "Chapter 3 Setting."
■ Maintenance switch (MAINT)
MAINT is used to restart GA932 module.
For details, refer to "Chapter 3 Setting."
■ Node number setting switch
Node number setting switch is a rotary switch for setting the Node number of
the unit on which GA932 module is installed.
For details, refer to "Chapter 3 Setting."
■ TC-net I/O loop optical connector
This connector is used to connect TC-net I/O optical cable.
Refer to "Appendix A.4 TC-net I/O loop transmission specification" for
applicable optical cable, "Chapter 2 Installation and Wiring" for wiring optical
cables.
■ Tool Connector
This tool connector is for maintenance of our company. Please use with
attached tool connector cap attached.
■ Slide lever
Operate when removing GA932 module from the base unit.
For details, refer to "Chapter 2 Installation and Wiring"
■ Fixing screw
This screw is to fix GA932 module to the base unit.
For details, refer to "Chapter 2 Installation and Wiring"
10
6F8C1590
GA932 is not removable when online. Do not insert or
CAUTION
remove GA932 module while the power is ON. Also,
Please do not connect or disconnect other modules and
cables while the power is ON.
G3 I/O does not do degeneracy recovery. G3 I/O is not
CAUTION
removable when online, GA932 does not perform access
check after disconnectiong abnormal G3 I/O.Turn off the
power of the basic unit and the expansion unit ,and then
restart it after replacing G3 I/O.
Mandatory
Mandatory
Hide quick links:
Table of Contents
