Table of Contents
Replacing an SD Card in a Mini-Storage Carrier For SD
Figure 29: Mini-Storage Module Carrier
1
Location of socket on motherboard
2
Alignment pegs
Replacing an SD Card in a Mini-Storage Carrier For SD
This topic describes how to remove and replace an SD card in a mini-storage carrier for SD (PID
UCS-MSTOR-SD). The carrier has one SD card slot on its top and one slot on its underside.
Population Rules For Mini-Storage SD Cards
• You can use one or two SD cards in the carrier.
• Dual SD cards can be configured in a RAID 1 array through the Cisco IMC interface.
• SD slot 1 is on the top side of the carrier; SD slot 2 is on the underside of the carrier (the same side as
Step 1
Power off the server and then remove the mini-storage module carrier from the server as described in
Mini-Storage Module Carrier, on page
Step 2
Remove an SD card:
a) Push on the top of the SD card, and then release it to allow it to spring out from the socket.
b) Grasp and remove the SD card from the socket.
Cisco APIC M3/L3 Server Installation and Service Guide
60
the carrier's motherboard connector).
59.
3
Securing clips
-
Maintaining the Server
Replacing a
- Quick Links:
- External Features
Hide quick links:
Table of Contents
