Mounting; Mounting Location Options - Bosch MIC IP fusion 9000i Installation Manual

MIC IP fusion 9000i

7

7.1

MIC cameras are designed for easy installation in various locations such as directly onto

buildings and poles suitable to support CCTV equipment.

Select a secure installation location and mounting position for the device. Ideally, this is a

location where the device cannot be interfered with either intentionally or accidentally.

Ensure that the location has the appropriate clearance from power and lightning conductors,

in accordance with NEC725 and NEC800 (CEC Rule 16-224 and CEC Section 60).

Do not install the device near:

–

–

Notice!

Heat sources may obscure the thermal image

Heat sources in the direct FOV of the thermal camera or which can reflect from thermally

reflective sources might obscure the thermal image.

4

Caution!

Risk of lightning strikes

If the camera is installed in a highly exposed location where lightning strikes may occur, then

Bosch recommends installing a separate lightning conductor within 0.5 m (1.6 ft) of the

!

camera and at least 1.5 m (4.9 ft) higher than the camera. A good earth bonding connection

to the camera housing itself will provide protection against damage from secondary strikes.

The camera housing itself is constructed to cope with secondary strikes. If the correct

lightning protection is applied, then no damage to the internal electronics or camera should

result.

Installation in a damp environment (for example, near a coastline)

The fasteners shipped with the camera are designed to resist corrosion. Always use Bosch-

supplied screws and other fasteners when installing the camera.

The camera head has factory-installed plastic screws that prevent corrosion in the screw holes

when no MIC sunshield accessory is attached. Do not remove these screws until you install a

sunshield accessory. For complete details, refer to the installation instructions for the

sunshield accessory.

Before installation, inspect the metal parts of the camera for paint that is chipped or

otherwise damaged. If you notice any paint damage, touch up the damage with paint or

sealants available locally.

Avoid installation practices that may allow the camera's metal mountings to contact materials

such as stainless steel. Such contact can result in galvanic corrosion and degrade the

cosmetic appearance of the camera. These cosmetic damages caused by improper installation

are not covered by warranty as they do not affect the functionality of the camera.

Bosch Security Systems

Any heat sources

Any overhead power lines, power circuits, or electrical lights, or where the device may

contact power lines, circuits, or lights

Ensure that the selected mounting surface is capable of supporting the combined weight

of the camera and mounting hardware (sold separately) under all expected conditions of

load, vibration, and temperature.

Installation Manual

Mounting | en

17

2018.09 | 1.1 | F.01U.334.820