Summary of Contents for HP StorageWorks ESL E-Series
Page 1
ESL E-Series Interface Manager StorageWorks Replacement Instructions Caution: Parts can be damaged by Note: This part is not hot-pluggable. electrostatic discharge. Keep parts in their It is necessary to power down the library containers until needed. Ensure you are to replace this part. properly grounded when touching static- sensitive components.
Page 2
Removal Identify the interface manager. It is located in the top cluster, to the Remove all cables immediate connected to the right of interface manager, the cluster after noting where controller. they are connected. Memory Module Relocation Use a #2 Phillips screwdriver to loosen the captive screws in the black ejector handles at both ends of the interface manager.
Page 3
8 through 10, your replacement interface manager card retains the configuration of the original card. To verify or change these settings, refer to the HP StorageWorks Interface Manager and Command View TL User Guide. Verify that the status LEDs indicate a normal state.
Getting help • HP product information: http://www.hp.com/products/tapestorage • HP technical support and phone numbers: http://www.hp.com/support • HP StorageWorks Library and Tape Tools (L&TT) diagnostic software: http://www.hp.com/support/tapetools • Interface Manager and HP StorageWorks Command View TL: http://www.hp.com/support/cvtl Close the back door of the library.