Smart Card Board - HP OMEN Maintenance And Service Manual
15 series laptop pc
Hide thumbs
Also See for OMEN:
- Maintenance and service manual (112 pages) ,
- User manual (38 pages) ,
- Setup instructions (15 pages)
Table of Contents
Smart card board
Description
Smart card board
Before removing the card reader, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the any smart cards and memory cards.
5.
Remove the base enclosure (see
6.
Remove the battery (see
7.
Remove the hard drive (see
8.
Remove the SSD (see
Remove the smart card reader:
NOTE:
Before you remove the smart card reader, make sure nothing (memory card or plastic insert) in
inserted in the reader.
1.
Disconnect the smart card reader cable (1) from the connector on the system board.
2.
Remove the two Phillips screws (2) that secure the smart card reader to the computer.
3.
Remove the smart card reader from the computer (3).
Reverse this procedure to install the smart card reader.
48
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Base enclosure on page
Battery on page
46).
Hard drive (HDD) on page
Solid-state drive (SSD) on page
35).
38).
40).
Spare part number
L14374-001
- Quick Links:
- Product Description
- Right Side
- Lights
Hide quick links:
Table of Contents
