Table of Contents
Filter by specific event: TRAP list selection ordered by severity
|
i
nformation
This trap is sent upon completion of a UPS diagnostic test.
The UPS status is normal. Load protected by UPS.
Alarm cancelled. All alarms are disabled.
The UPS has cancelled the shutdown procedure to agent.
This trap is sent each time an alarm is removed from the alarm table. TRAP 4: entry removed
The Input supply has been restored.
The communication between UPS and the agent has been restored. TRAP 25
NET VISION is restarting.
EMD Sensor Not over high temperature.
EMD Sensor Not over high humidity.
EMD input2 is restored.
EMD Sensor Not under low temperature.
EMD Sensor Not under low humidity.
EMD input1 is restored.
|
w
arning
The UPS is operating on battery power.
The UPS output is in overload
The battery is in alarm.
The battery test has detected a weak battery.
Load supplied by automatic Bypass.
A warning message has been sent to shutdown agent.
This TRAP is sent each time an alarm is inserted into to
the alarm table.
Redundancy is lost.
The UPS has switched to battery backup power.
The UPS internal temperature has reached the threshold. TRAP 17
A preventive alarm has been detected by the UPS.
A shutdown command has been sent to agent.
|
C
ritiCal
The UPS is about to switch off the output power.
The battery has been detected as discharged.
A critical alarm has been detected on the UPS.
UPS is no longer communicating with the agent.
The battery has been disconnected from the UPS.
The battery is near of the end of backup time.
The load has been disconnected from the UPS.
EMD Sensor detected low temperature.
EMD Sensor detected low humidity.
EMD input1 is active.
EMD Sensor detected high temperature.
EMD Sensor detected high humidity.
EMD input2 is active.
44
GB
Not available for all UPS
TRAP 22
TRAP 24: General alarm no longer present
TRAP 26: Sent if the server shutdown has been enabled
TRAP 23
TRAP 27
TRAP 31
TRAP 35
TRAP 39
TRAP 29
TRAP 33
TRAP 37
TRAP 1: Sent every minute with remaining backup time
TRAP 6: Output load rate more than 100%.
TRAP 11
TRAP16: Test failed
TRAP 18: On bypass and not eco mode activated
TRAP 20: Sent if the server shutdown has been enabled
TRAP 3: New entry added
TRAP 7
TRAP 15: Battery discharging – sent once
TRAP 19 (including general alarm)
TRAP 21: Sent if the server shutdown has been enabled
TRAP 5: Imminent stop
TRAP 9
TRAP 12
TRAP 14
TRAP 8
TRAP 10: Battery low / end of backup time
TRAP 13: Load off or on standby mode
TRAP 28
TRAP 32
TRAP 36
TRAP 30
TRAP 34
TRAP 38
NET-VISION 7 - SOCOMEC
Hide quick links:
Table of Contents
