Example Stacker Configurations
The stacker is used by changing the position depending on the paper size of the printed materials.
Important
• Depending on the types of paper, it cannot be stacked in the Position 2, Position 3, or Position 4. In this
case, use the Position 1.
Stacking Printed Materials (Position 1)
This is the position when you stack the printed materials.
Pull down the rod (fixed) (C) toward you. Set the rod (adjustable) in the groove (B) at the lower of the arm,
and then set the flapper (A) vertically so that the stacker configuration is the Position 1.
Stacking Printed Materials with a 36-inch Width or of A0 Portrait (Position 2)
This is the position when you stack the printed materials with a 36-inch width or of A0 portrait.
• Paper orientation
Portrait
• Supported paper size
◦ 36"x48" (ARCH E) 36.00 x 48.00 inches (914.4 x 1219.2 mm)
◦ A0 33.11 x 46.81 inches (841.0 x 1189.0 mm)
Set the rod (adjustable) in the groove (B) at the upper of the stand, and then push down the rod (fixed) (C)
to the printer side. Then set the flapper (A) vertically so that the stacker configuration is the Position 2.
118
- Quick Links:
- Online Manual
- List of Support Code for Error
Hide quick links:
Troubleshooting
