Error Print Mode; Mediatype; Imageadapt - Brother HL-1050 Technical Reference Manual
Hide thumbs
Also See for HL-1050:
- Technical reference manual (517 pages) ,
- Service manual (305 pages) ,
- User manual (91 pages)
Table of Contents
2.7.3.
Error print mode
Command
@PJL SET ERRORPRINT= parameter
@PJL DEFAULT ERRORPRINT parameter
(parameter)
OFF:
Do not print an error print
ON:
Print an error print
EXCEPTCDCC: Print an error print
Explanation
This command switches the error print mode. EXCEPTCDCC is almost the same as ON, but it does not give an
error print for a CDCC line error. This option cannot be cleared even if the INITIALIZE command or a factory
reset is performed.
2.7.4.
MEDIATYPE
Command
@PJL SET MEDIATYPE=parameter
@PJL DERAULT MEDIATYPE =parameter
(parameter)
REGULAR:
Plain paper --- Default
THICK:
Thick paper --- Fixing unit temperature is higher than REGULAR.
THICK2:
Very thick paper --- Fixing unit temperature is higher than THICK.
TRANSPARENCY: OHP sheet
THIN:
Thin paper (HL-1250/1270N/P2500) --- Fixing unit temperature is lower than REGULAR.
Explanation
This command changes the fixing unit temperature control.
2.7.5.
IMAGEADAPT
Command
@PJL SET IMAGEADAPT=parameter
@PJL DEFAULT IMAGEADAPT=parameter
(parameter)
ON:
Take IMAGEADAPT --- Default
AUTO:
Take IMAGEADAPT
OFF:
Do not take IMAGEADAPT
Explanation
This command defines whether to take IMAGEADAPT or not.
When the printer memory is insufficient, a memory full error may occur. If IMAGEADAPT is ON, the memory
full can be avoided by thinning out dots.
2.7.6.
SOURCETRAY (For HL-1070/1250/1270N/P2500 only)
Command
@PJL SET SOURCETRAY=parameter
@PJL DEFAULT SOURCETRAY=parameter
(parameter)
AUTO:
DUAL (If a paper empty error occurs, tray is automatically switched to the other one.)
TRAY1:
TRAY1
TRAY2:
TRAY2
APPENDIX D REFERENCE LIST OF HL-1050/1070/1250/1270N/P2500 PJL COMMANDS - 11
99/08/03
Chapters
Table of Contents
