Using Standard Characters - Brother HL-1050 Technical Reference Manual
Hide thumbs
Also See for HL-1050:
- Technical reference manual (517 pages) ,
- Service manual (305 pages) ,
- User manual (91 pages)
Table of Contents
99/08/03
• m
specifies the tab based on the current line space setting.
i
• The value of m
• The tab stops must be set in ascending order. If you specify a channel's tab settings in any other
order, any previous settings made for that channel are cleared.
• Vertical tab settings are not affected by subsequent changes in the line spacing setting.
• Esc b n 0 clears the vertical tab settings set for channel n.
• You can select a channel using the Esc / command and move the print position to its tab stops using
the VT control code.
LPRINT CHR$(27); CHR$(98); CHR$(1); CHR$(10); CHR$(20); CHR$(0);
'Set tab stops at lines 10 and 20.
Select vertical tab channel
Esc/n
• This command allows you to select a set of vertical tabs (or channel) that you defined using the Esc b
command.
• All subsequent vertical tab commands use the selected tab channel's settings.
• n must be in the range from 0 to 7.
• The default channel is channel 0. Channel 0 is the current channel when the printer is first switched
on or after a reset with the Esc @ command.
• There are no default vertical tab settings for any channel.
LPRINT CHR$(27); CHR$(47); CHR$(5); 'Select vertical tab channel 5
Vertical tab
VT
• The VT control code (ASCII 11) moves the current print position one vertical tab stop down the
page. The current vertical tab channel's settings are used.
• If you have not previously selected a vertical tab channel with the Esc / command, channel 0, the
default channel is used.
• If you have not set any vertical tab stops for the current channel with either the Esc B, Esc b, or Esc
e 1 commands, the print position is moved down one line using the current line space setting.
• If there are no tab stops below the current print position a line feed is performed.
• If no tab stops have been set a carriage return and line feed are performed.
LPRINT CHR$(11); ' Vertical tab
6.5.
Using Standard Characters
Set pitch to 10 characters per inch
EscP
This command sets the printing pitch to 10 characters per inch (cpi).
LPRINT CHR$(27); CHR$(80); 'Set pitch to 10 cpi
Set pitch to 12 characters per inch
EscM
This command sets the printing pitch to 12 characters per inch (cpi).
LPRINT CHR$(27); CHR$(77); 'Set pitch to 12 cpi
Select / cancel proportional spacing
Escpn
• This command allows you to turn proportional spacing on or off.
• Setting n to 1 turns proportional spacing on. Subsequent text is printed proportionally spaced.
• Setting n to 0 turns proportional spacing off. Subsequent text is printed monospaced.
• When you specify the value for n you can use the character codes for '0' and '1' (48 and 49) instead
of 0 and 1.
• Selecting proportional spacing cancels condensed character mode.
must be in the range 0 to 255.
i
(27)(47)n
<1Bh><2Fh>n
(11)
<0Bh>
(27)(80)
<1Bh><50h>
(27)(77)
<1Bh><4Dh>
(27)(112)n
<1Bh><70h>n
CHAPTER 6 EPSON - 16
Chapters
Table of Contents
