Brother HL-L2395DW Online User's Manual page 467
Hide thumbs
Also See for HL-L2395DW:
- Service manual (340 pages) ,
- Reference manual (27 pages) ,
- Product safety manual (26 pages)
Table of Contents
Error Message
Self-Diagnostic
Size Error DX
Size Mismatch
Toner Ended
Toner Low
Wait for a while
HL-L2395DW/MFC-L2730DW/MFC-L2750DW/MFC-L2751DW/MFC-L2770DW/
MFC-L2771DW
Error Message
2-sided Disable
Cause
The temperature of the fuser unit
does not rise to a specified
temperature within the specified time.
The fuser unit is too hot.
The paper size specified in the printer
driver and the machine's paper size
setting are not available for automatic
2-sided printing.
The paper in the tray is not the
correct size and is not available for
automatic 2-sided printing.
The paper in the tray is not the
correct size.
The toner cartridge is at the end of its
life. The machine stops all print
operations.
If the LCD displays this message, you
can still print. The toner cartridge is
near the end of its life.
The temperature of the inside of the
machine is too hot. The machine will
pause its current print job and go into
cooling down mode. During the
cooling down mode, you will hear the
cooling fan running while the LCD
displays Wait for a while.
Cause
The back cover of the machine is not
closed completely.
The 2-sided tray is not installed
completely.
Action
•
Press and hold
to turn the
machine off, and then turn it on
again.
•
If the problem continues, contact
Brother customer service.
•
(MFC-L2710DW/MFC-L2713DW/
MFC-L2715DW/MFC-L2716DW)
To prevent you from losing the
received fax data in the machine's
memory, transfer the data to
another Fax machine or to your
computer before turning off the
machine.
•
Press and hold
to turn the
machine off, wait a few seconds,
and then turn it on again. Leave
the machine idle for 15 minutes
with the power on.
Press Stop/Exit. Choose a paper
size supported by 2-sided printing.
Paper size available for automatic 2-
sided printing is A4.
Load the correct size of paper in the
tray and set the tray for that paper
size.
Paper size available for automatic 2-
sided printing is A4.
Load the correct size of paper in the
tray and set the size of paper to the
tray.
Replace the toner cartridge with a
new one.
Order a new toner cartridge now so a
replacement toner cartridge is
available when the LCD displays
Replace Toner.
Wait until the machine has finished
cooling down. Make sure all vents on
the machine are clear of obstructions.
When the machine has cooled down,
the machine will resume printing.
If the fan is not spinning, disconnect
the machine from the power for
several minutes, then reconnect it.
Action
Close the back cover of the machine
until it locks in the closed position.
Install the 2-sided tray firmly in the
machine.
460
- Quick Links:
- Control Panel Overview
Hide quick links:
Table of Contents
