Table of Contents
P54A/B/C/E
Signal Name
TMEM3Ph
1-pole / 3-pole Trip (13)
TMEMANY
1-pole / 3-pole Trip (13)
4.3
AUTORECLOSE DDB SIGNALS
The following table lists all the DDB signals used in the CB control and Autoreclose logic system:
DDB Signal
DDB Signal
Name
Number
1P DTime
1554
1P Reclaim TComp
1568
1P Reclaim Time
1567
2/3 Ph Fault
527
3 Ph Fault
528
3P Dead Time IP
853
3P Dtime
1560
3P DTime1
1556
3P DTime2
1557
3P DTime3
1558
3P DTime4
1559
3P Reclaim TComp
1570
3P Reclaim Time
1569
A/R CB Unhealthy
307
A/R Lockout
306
A/R No Checksync
308
Any Trip
522
AR 1pole in prog
845
AR 3pole in prog
844
AR Enable
1384
AR Enable CB
1609
P54xMED-TM-EN-1
Source Module
3-phase AR Cycle Selection (21)
Evolving Fault (20)
3-phase AR Cycle Selection (21)
Source Module
1-phase AR Dead Time (24)
Reclaim Time (35)
Reclaim Time (35)
CB Trip Conversion (63)
CB Trip Conversion (63)
3-phase AR Dead Time (25)
3-phase AR Dead Time (25)
3-phase AR Dead Time (25)
3-phase AR Dead Time (25)
3-phase AR Dead Time (25)
3-phase AR Dead Time (25)
Reclaim Time (35)
Reclaim Time (35)
CB Healthy and System Check Timers (39)
Autoreclose Lockout (55)
CB Healthy and System Check Timers (39)
CB Trip Conversion (63)
Destination Module
Sequence Counter (18)
Evolving Fault (20)
Successful AR Signals
Reclaim Time Logic
Successful AR Signals
Reclaim Time Logic
Force 3-phase Trip
Autoreclose Lockout
CB In Service
AR OK
Force 3-phase Trip
Evolving Fault
CB Autoclose Logic
CB Healthy and System Check Timers Logic
AR Shot Counters
Reset CB Lockout
Pole Discrepancy
Autoreclose Lockout
AR Initiation
CB Autoclose Logic
CB Control
1-phase AR Cycle Selection
Dead Time Start Enable
Pole Discrepancy
3-phase AR Cycle Selection
AR Enable
AR Enable
AR OK
AR Modes Enable
Chapter 7 - Autoreclose
Description
Signal to remember that Autoreclose was
initiated by a 3-phase fault
Signal to remember that Autoreclose was
initiated by an AnyTrip
Destination Module
141
Table of Contents
Troubleshooting
