Ipv6 Static/Default Route Settings - D-Link xStack DGS-3400 Series Reference Manual
Web ui reference guide for layer 2+ managed gigabit ethernet switch
Hide thumbs
Also See for xStack DGS-3400 Series:
- Reference manual (629 pages) ,
- Cli reference manual (540 pages) ,
- Cli manual (463 pages)
Table of Contents
x Stack
To remove an entry, click the corresponding
window to configure:
The following fields can be set:
Parameter
IP Address
Subnet Mask
Gateway
Metric (1-65535)
Backup State
Click Apply to implement the changes. To return to the IPv4 Static/Default Route Settings window, click the
Static/Default Route Entries
IPv6 Static/Default Route Settings
A static entry of an IPv6 address can be entered into the Switch's routing table for IPv6 formatted addresses.
To view this window, click Administration > Static/Default Route Settings > IPv6 Static/Default Route Settings, as shown
below.
This window shows the following values:
Parameter
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
button. To add a new entry, click the Add button, revealing the following
Figure 2 - 58 Static/Default Route Settings - Add window
Description
Allows the entry of an IP address that will be a static entry into the Switch's Routing Table.
Allows the entry of a subnet mask corresponding to the IP address above.
Allows the entry of an IP address of a gateway for the IP route above.
Allows the entry of a routing protocol metric representing the number of routers between
the Switch and the IP address above.
The user may choose between Primary and Backup. If the Primary Static/Default Route
fails, the Backup Route will support the entry. Please take note that the Primary and
Backup entries cannot have the same Gateway.
link.
Figure 2 - 59 IPv6 Static/Default Route Settings window
Description
64
Show All
Table of Contents
