Ip Tunnel Settings - D-Link xStack DGS-3400 Series Reference Manual
Web ui reference guide for layer 2+ managed gigabit ethernet switch
Hide thumbs
Also See for xStack DGS-3400 Series:
- Reference manual (629 pages) ,
- Cli reference manual (540 pages) ,
- Cli manual (463 pages)
Table of Contents
x Stack
The following settings can be configured:
Parameter
Interface Name
State
Metric
Click Apply to implement changes made.
IP Tunnel Settings
The Switch supports IP tunneling. The idea behind this feature is to be able to integrate IPv6 into and coexist with existing IPv4
networks. It is expected that IPv4 and IPv6 hosts will need to coexist for a substantial time during the steady migration from IPv4
to IPv6, and the development of transition strategies, tools, and mechanisms has been part of the basic IPv6 design from the start.
This IPv6 tunneling mechanism is one of D-Link's strategies for solving the transition from IPv4 to IPv6.
To configure the settings, click Administration > IP Tunnel Settings, as shown below.
To remove an entry, click the corresponding
shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 173 RIPng Interface Settings - Edit window
Description
The name of the interface for the RIPng configuration.
Enable or disable the RIPng state on the specific IP interface. If the state is Disabled, then
RIPng packets will not be transmitted or received by the interface. The default setting is
Disabled.
Enter the cost value of an interface. The RIPng route that was learned from the interface
will add this value as a new route metric. The default value is 1.
Figure 2 - 174 IP Tunnel Settings window
button. To Add a new name of the interface, click Add to see the window, as
148
Table of Contents
