Enabling Multicast Source Port Filtering; Enabling Dropping Unknown Multicast Data - HP MSR1002-4 Configuration Manual
Flexnetwork msr series
Hide thumbs
Also See for MSR1002-4:
- Installation manual (46 pages) ,
- Configuration manual (108 pages) ,
- Command reference manual (471 pages)
Table of Contents
Step
2.
Enter
interface view or Layer 2
aggregate interface view.
3.
Configure a multicast group
policy on the port.
Enabling multicast source port filtering
This feature is supported only on the following ports:
•
Layer 2 Ethernet ports on the HMIM-8GSW, HMIM-24GSW, and HMIM-24GSW-PoE.
•
Fixed Layer 2 Ethernet ports on the following routers:
MSR1002-4/1003-8S.
MSR2004-24/2004-48.
MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A).
MSR958 (JH300A/JH301A).
This feature enables the device to discard all multicast data packets and to accept multicast protocol
packets. You can enable this feature on ports that connect only to multicast receivers.
You can enable this feature for the specified ports in IGMP-snooping view or for a port in interface
view. For a port, the configuration in interface view has the same priority as the configuration in
IGMP-snooping view, and the most recent configuration takes effect.
Enabling multicast source port filtering for the specified ports
Step
1.
Enter system view.
2.
Enter IGMP-snooping view.
3.
Enable multicast source port
filtering.
Enabling multicast source port filtering for a port
Step
1.
Enter system view.
2.
Enter
interface view.
3.
Enable multicast source port
filtering.
Enabling dropping unknown multicast data
This feature is supported only on the following ports:
•
Layer 2 Ethernet ports on the HMIM-8GSW, HMIM-24GSW, HMIM-24GSW-PoE, and
SIC-4GSW.
•
Fixed Layer 2 Ethernet ports on the following routers:
Command
Layer
2
Ethernet
interface
interface-number
igmp-snooping
ipv4-acl-number [ vlan vlan-list ]
Command
system-view
igmp-snooping
source-deny port interface-list
Command
system-view
Layer
2
Ethernet
interface
interface-number
igmp-snooping source-deny
interface-type
group-policy
interface-type
27
Remarks
N/A
By default, no multicast group
policies exist on a port, and hosts
attached to the port can join any
multicast groups.
Remarks
N/A
N/A
By default, multicast source port
filtering is disabled.
Remarks
N/A
N/A
By default, multicast source port
filtering is disabled.
- Quick Links:
- Table of Contents
- Introduction to Multicast
Hide quick links:
Table of Contents
Troubleshooting
