Setting the Remote Device (KOYO PLC)
Use the following procedure to set the KOYO DL-series PLC.
The DL-series PLCs are manufactured by KOYO Electronics Industries.
Contact KOYO Electronics Industries for further information.
Note
1.
Start DirectSoft32.
2.
Create a project.
3.
Start NetEdit3.
4.
Click the ECOM Settings Tab followed by the General Button in the Configuration Area to set
the network parameters.
Parameter
Select the Use the following IP settings Option before setting the following items.
IP Address
Subnet mask
Others
5.
Click the ECOM Settings Tab followed by the Peer to Peer Config Button in the Configuration
Area to set the MODBUS/TCP parameters.
Parameter
RX/WX Device Number
Select the Modbus-TCP Option before setting the following items.
IP Address
Port
Unit ID
Note: Specify an IP address that is not in use by any other device on the same network.
Check with your network administrator for unused IP addresses.
2.9 Communications with a KOYO PLC (MODBUS/TCP Protocol)
Using Automatic Reception with the MP3000 as a Slave
Description
192.168.1.2
255.255.255.0
As required.
Description
1
192.168.1.1
10001
0
2-255