Notes On Safety; Qualified Personnel; Correct Usage; Edition - Siemens SIMATIC S7-200 System Manual
Hide thumbs
Also See for SIMATIC S7-200:
- System manual (554 pages) ,
- Getting started (65 pages) ,
- Manual (55 pages)
Table of Contents
Notes on Safety
!
!
!
Qualified Personnel
Correct Usage
!
Trademarks
Copyright Siemens AG 2000 All rights reserved
The reproduction, transmission or use of this document or its
contents is not permitted without express written authority.
Offenders will be liable for damages. All rights, including rights
created by patent grant or registration of a utility model or design, are
reserved.
Siemens AG
Bereich Automatisierungs- und Antriebstechnik
Geschaeftsgebiet Industrie-Automatisierungssysteme
Postfach 4848, D-90327 Nuernberg
Siemens Aktiengesellschaft
This manual contains notices which you should observe to ensure your own personal safety, as
well as to protect the product and connected equipment. These notices are highlighted in the ma-
nual by a warning triangle and are marked as follows according to the level of danger:
Danger
indicates that death, severe personal injury or substantial property damage will result if proper
precautions are not taken.
Warning
indicates that death, severe personal injury or substantial property damage can result if proper
precautions are not taken.
Caution
indicates that minor personal injury or property damage can result if proper precautions are not
taken.
Note
draws your attention to particularly important information on the product, handling the product,
or to a particular part of the documentation.
Only qualified personnel should be allowed to install and work on this equipment. Qualified
persons are defined as persons who are authorized to commission, to ground, and to tag circuits,
equipment, and systems in accordance with established safety practices and standards.
Note the following:
Warning
This device and its components may only be used for the applications described in the catalog or
the technical description, and only in connection with devices or components from other manu-
facturers which have been approved or recommended by Siemens.
This product can only function correctly and safely if it is transported, stored, set up, and instal-
led correctly, and operated and maintained as recommended.
SIMATIC , SIMATIC NET
SIEMENS AG.
Third parties using for their own purposes any other names in this document which refer to
trademarks might infringe upon the rights of the trademark owners.
and SIMATIC NET are registered trademarks of
Disclaimer of Liability
We have checked the contents of this manual for agreement with the
hardware and software described. Since deviations cannot be
precluded entirely, we cannot guarantee full agreement. However,
the data in this manual are reviewed regularly and any necessary
corrections included in subsequent editions. Suggestions for
improvement are welcomed.
Siemens AG 2000
Subject to technical change.
6ES7298-8FA21-8BH0
- Quick Links:
- Installing an S7-200 Micro Plc
- Configuration
Hide quick links:
Table of Contents
