Portal Configuration Examples; Configuring Direct Portal Authentication - HP 5120 SI Series Security Configuration Manual
Hide thumbs
Also See for 5120 SI Series:
- Command reference manual (395 pages) ,
- Installation manual (48 pages) ,
- Specification (33 pages)
Table of Contents
To do...
Clear TCP spoofing statistics
Portal configuration examples
Configuring direct portal authentication
Network requirements
As shown in
The host is directly connected to the switch and the switch is configured for direct authentication. The
•
host is assigned with a public network IP address either manually or through DHCP. Before passing
portal authentication, users can access only the portal server. After passing portal authentication,
users can access Internet resources.
A RADIUS server serves as the authentication, authorization, and accounting server.
•
Figure 40 Network diagram
Host
2.2.2.2/24
Gateway：2.2.2.1/24
Configuration procedure
NOTE:
Configure IP addresses for the host, switch, and servers as shown in
•
can reach each other.
Configure the RADIUS server properly to provide authentication and accounting functions for users.
•
1.
Configure the portal server (iMC PLAT 3.20)
NOTE:
This example assumes that the portal server runs on iMC PLAT 3.20-R2602P13 and iMC UAM
3.60-E6301.
# Configure the portal server.
Log in to the iMC management platform and select the Service tab. Then, select Portal Service
Management > Server from the navigation tree to enter the portal server configuration page, as shown
in
Figure
46.
Figure
45:
Vlan-int100
Vlan-int2
2.2.2.1/24
192.168.0.100/24
Switch
Use the command...
reset portal tcp-cheat statistics
Portal server
192.168.0.111/24
RADIUS server
192.168.0.112/24
135
Remarks
Available in user
view
Figure 45
and make sure that they
Table of Contents
Troubleshooting
