Table of Contents
CLOCK/TIMER
STANDBY
ON
CD 1
CD 2
CD 3
CD REC ORD ABL
-
R8
FW
DISPLAY
MIC
LEV EL
MIC
Clock setting
It is possible to set the clock by using a time signal which is
broadcast together with the RDS signal. This only works if the
RDS station is sending this time signal.
Automatic clock setting
1 Tune to an RDS station (see "Tuner").
2 Press CLOCK/TIMER on the set for more than 3 seconds.
blinks for a maximum of 90 seconds.
y
Then the time is displayed.
If
is displayed, there is no time signal
transmitted. In that case you have to tune to another
RDS station or set the clock manually.
Note: The time signal broadcasted from certain RDS stations
may not always be accurate. If you find there a
discrepancy in clock time, set your clock manually and
the time will then run accurately.
Manual clock setting
1 Press as often as necessary y STANDBY ON on the set to
switch the set to standby.
2 Press CLOCK/TIMER on the set.
3 Rotate í JOG CONTROL ë to select the clock.
is displayed and X starts blinking.
y
28
AN ALO G
DIG ITA L /
AU X
TU NE R
OR
iR SE NS
S/ TA
NE W
RD S
ER
K/ TI M
CL OC
E MIN I HIF I SYS
TEM
XT
CD TE
LO SE
OP EN /C
4 Press YES to confirm the selection.
The day of the week digit blinks.
y
5 Rotate í JOG CONTROL ë to set the day.
6 Use à SEARCH or á SEARCH on the set to move from
day of the week to hour.
7 Rotate í JOG CONTROL ë to set the hour.
8 Repeat steps 6 and 7 to set the minutes.
9 Press YES to confirm the settings.
- Quick Links:
- Setup Information
- Technical Data
Hide quick links:
Table of Contents
