Quick Links
User's Information Manual
• Before operating this boiler, READ this manual.
• DO NOT attempt to install, service or repair this boiler yourself. There are no user serviceable parts. Contact a
qualified service agency if your boiler needs repair or maintenance. Ask your gas supplier for a list of qualified
service agencies.
• A qualified service agency should inspect the venting system of this boiler on an annual basis.
Your gas boiler must be installed and serviced by a qualified service agency or gas
supplier. The lack of proper service can result in a dangerous condition.
This manual must be left with owner, hung on or
adjacent to the boiler. Owner should retain manual for
future reference.
Residential • Gas fired • Hot Water Boilers
Direct-Vent Sealed Combustion Condensing Boiler
Model J-390
FOR YOUR SAFETY:
WARNING: If the information in this manual is
not followed exactly, a fire or explosion may
result causing property damage, personal
injury or loss of life.
__
DO NOT store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
__
WHAT TO DO IF YOU SMELL GAS
• DO NOT try to light any appliance.
• DO NOT touch any electrical switch
• DO NOT use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas suppli-
er's instructions.
• If you cannot reach your gas supplier, call
the fire department.
__
Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
Printed in Canada 0808
Part No. 83-5737
Publication No. J-UIM
Related Manuals for Slant/Fin J-390
Summary of Contents for Slant/Fin J-390
- Page 1 Residential • Gas fired • Hot Water Boilers User’s Information Manual Direct-Vent Sealed Combustion Condensing Boiler Model J-390 FOR YOUR SAFETY: • Before operating this boiler, READ this manual. • DO NOT attempt to install, service or repair this boiler yourself. There are no user serviceable parts. Contact a qualified service agency if your boiler needs repair or maintenance.
-
Page 2: Lighting Instructions
Figure 1. Location and identification of parts. WELCOME TO OUR VALUED CUSTOMER DO NOT use this boiler if any part has You are now the owner of a Slant/Fin Jaguar gas-fired boiler, been underwater. Immediately call a another quality heating product designed and manufactured... - Page 3 If the boiler is vented horizontally through the wall, the out- just before cold weather starts. Jaguar J-390 boiler may side termination, louvers and screen should be checked for be installed and vented either as direct-vent boiler, which any debris blocking the opening and cleaned as required.
-
Page 4: Air Intake
Jaguar Model J-390 4" DIA 102mm (4") DIA. VENT PIPE VENT PIPE VENT AIR INTAKE TERMINATION (DO NOT BLOCK) OUTSIDE WALL Figure 4. Non-direct vent, sidewall venting. - Page 5 Jaguar Model J-390 VENT TERMINATION 2" M I N AIR INTAKE (DO NOT BLOCK) 4" DIA VENT PIPE 102mm (4") DIA. VENT PIPE Figure 5. Non-direct vent, venting through the roof. VENT CHIMNEY TERMINATION TOP PLATE 102mm (4") DIA. 4" DIA VENT PIPE...
- Page 6 Jaguar Model J-390 DRAIN VACUUM BREAKER, LEAVE OPEN PLASTIC TUBING NEUTRALIZING UNIT (IF REQUIRED) CONDENSATE PUMP (IF REQUIRED) DRAIN INSIDE BUILDING Figure 7. Condensate disposal system 2. CONDENSATE REMOVAL SYSTEM indicate about 83 to 103 kPa (12 to 15 psi) pressure when temperature is about 21°...
- Page 7 Jaguar Model J-390 The combustion air supply must not be susceptible to C. Use only your hand to turn the gas supply shut off contaminants, which may cause corrosion or other valve. Never use tools. If the supply shut off will not damage to the heat exchanger and components of the turn by hand, don’t try to repair it, call a qualified...
- Page 8 Jaguar Model J-390 Removing Jacket Front Panel The setting range is between 40° to 85°C (104° to 185°F). 1. Turn black screws 1/4 turn to open position. 3. While “t” is blinking, DHW tank temperature may 2. Remove front panel.
- Page 9 Jaguar Model J-390 Jaguar Boiler Display Board “Boiler Operation Status” Mode Description & Temperature Display Display Boiler is on stand-by mode. Temperature display shows supply water Temp. Space heating mode. Temperature display shows supply water Temp. Domestic hot water mode.
- Page 10 Jaguar Model J-390 Table 2: Viewing and Changing Temperatures Press “Select” button for viewing different modes on “Mode Display” Mode Description & Temperature Display Display Space heating supply water temperature could be changed by pressing “Up/Down” button. Settable from 32° to 85°C (90°F to Blinking 185°F) (steps of 0.55°C [1°F]).
- Page 11 Jaguar Model J-390 DIAGNOSTIC ERROR CODES ERROR INDICATION CODE WARNING: If an operational problem has occurred, the boiler will Water Outlet Sensor Open shut off and show an “A”, “E” or “H” in the mode dis- play, along with an error code in the temperature dis- Water Inlet Sensor Open play.
- Page 12 ©Slant/Fin Corp. 2008 SLANT/FIN LTD/LTEE, 6450 Northam Drive, Mississauga, Ontario L4V 1H9 • Phone: (905) 677-8400 / FAX: (905) 677-1829 / Order Desk Fax: (905) 677-9015 www.slantfin.ca / E-mail: [email protected] / [email protected]...