Installing The Rigging Grommet - Yamaha F200B Service Manual
Hide thumbs
Also See for F200B:
- Owner's manual (122 pages) ,
- Owner's manual (90 pages) ,
- Rigging manual (329 pages)
Table of Contents
1. Remove the engine ECM cover 1, and
then remove the plug 2.
1
2. Install the water pressure sensor 3 to
the water pressure sensor adapter 4,
and then tighten the water pressure sen-
sor 3 to the specified torque.
4
3
Water pressure sensor 3:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
3. Install a new gasket 5 and the water
pressure sensor assembly a, and then
tighten
the
water
adapter 4 to the specified torque.
5
4 a
Water pressure sensor adapter 4:
23 N·m (2.3 kgf·m, 17.0 ft·lb)
4. Remove the cap, and then connect the
water pressure sensor coupler b.
2
pressure
sensor
4
Rigging grommet mounting
5. Install the engine ECM cover.
Installing the rigging grommet
1. Route each harness through the proper
hole in the rigging grommet. See "Rig-
ging grommet description" (3-9) for the
detailed description of the rigging grom-
met.
2. Align the white tape a on the battery
cable with the outer end of the rigging
grommet.
3. Install the retaining plate 1.
4. Install the rubber seal 2.
2
1
TIP:
Make sure that the rubber seal is installed
securely.
b
3
a
3-14
Chapters
Table of Contents
Troubleshooting
