Table of Contents
en
Installation
instructions
Important information:
These installation instructions refer to
various models.
Not all steps are required for some
models.
The appliance may be connected
only by an authorised fitter
according to these installation
instructions.
Always connect the water before
the power.
In addition to the statutory national
regulations, observe the connection
conditions of the electricity and
water supply companies.
Keep the installation instructions in
a safe place.
Appliance and installation dimensions
15
Installation location
Warning:
The appliance is very heavy, for empty
weight see the following table.
Basic model
Basic model
Model with dispenser
Model with home bar
Model with home bar
Model with dispenser&home bar
Install the appliance in a dry, well
ventilated room. The installation
location should neither be exposed to
direct sunlight nor near a heat source,
e.g. a cooker, radiator, etc.
If installation next to a heat source is
unavoidable, use a suitable insulating
plate or observe the following minimum
distances to a heat source:
- 3 cm to an electric cooker.
- 30 cm to an oil or solid fuel cooker.
The floor on which the appliance is to
be installed must be rigid. If required,
reinforce the floor (appliance is very
heavy, unloaded approx. 145 kg,
loaded up to 400 kg). To ensure that
the ice maker functions correctly, the
appliance must be upright. To ensure
that the doors can open all the way,
observe lateral minimum distances
when installing the appliance in
a corner or recess (see section on
Appliance and installation
dimensions").
Unpacking the appliance
S Remove packaging material and
adhesive tape. (Adhesive residue on
the housing can be removed with the
adhesive side of the removed tape.
104 kg
To do this, repeatedly place the
104Kg
adhesive tape on the adhesive
113 kg
106Kg
residue and remove).
115 kg
115Kg
S Do not remove the transportation
protection devices from the shelves
and storage compartments until the
appliance has been installed.
S After installing the appliance, remove
the transportation protection devices
from the ice maker. To do this, pull
out the ice maker.
115Kg
Warning:
Before connecting the appliance to the
power supply, remove all the inner and
outer packaging material.
- Quick Links:
- Electrical Connection
Hide quick links:
Table of Contents
