Siemens SINUMERIK 828D Function Manual page 275
Hide thumbs
Also See for SINUMERIK 828D:
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages) ,
- Programming manual (822 pages)
Table of Contents
•
Speed or torque feedforward control is activated. In this case, a higher servo gain factor is set than displayed
with MD32200:
•
Filter for jerk limitation or dynamic response adaptation is activated. In this case, a lower servo gain factor is
set than displayed with MD32200.
Diagnostics for alarms
This information of the service display "Axis/spindle" is also used as diagnostics help when alarms occur, e.g.:
•
"Zero speed monitoring"
⇒ Following error > MD36030 $MA_STANDSTILL_POS_TOL (standstill tolerance)
•
"Contour monitoring"
⇒ Contour deviation > MD36400 $MA_CONTOUR_TOL (contour monitoring tolerance range)
•
"Speed setpoint limitation"
⇒ Speed setpoint > MD36210 $MA_CTRLOUT_LIMIT (maximum speed setpoint)
•
"Position monitoring"
⇒ Following error > MD36010 $MA_STOP_LIMIT_FINE (exact stop fine)
•
"Measuring system cannot be switched over"
⇒ Difference between Position actual value measuring system 1 and 2 > MD36500
$MA_ENC_CHANGE_TOL (max. tolerance for position actual value sensing)
•
"Clamping monitoring"
⇒ Following error > MD36050 $MA_CLAMP_POS_TOL (clamping tolerance with interface signal "Clamping
active")
The behavior of the NC control in response to individual alarms, and remedial action is described in:
References:
Diagnostic Manual
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
D1: Diagnostics tools
5.3 Service overview
275
Table of Contents
