Dtc P0101 (P0100) Maf Sensor Circuit Range/Performance Problem - Suzuki Grand Vitara XL-7 Service Manual
Hide thumbs
Also See for Grand Vitara XL-7:
- Owner's manual (274 pages) ,
- Specifications (4 pages) ,
- Owner's manual (656 pages)
Table of Contents
6-1-12 ENGINE DIAGNOSIS (RHZ ENGINE WITH TRIPLE-CONNECTOR ECM)
DTC P0101 (P0100) MAF SENSOR CIRCUIT RANGE/PERFORMANCE PROBLEM
WIRING DIAGRAM
Refer to DTC P0100.
DTC CONFIRMATION PROCEDURE
NOTE:
Check to make sure that the following conditions are satisfied when using this DTC CONFIRMATION PRO-
CEDURE.
D Intake air temp.: –8_C, 18_F or higher
D Engine coolant temp.: –8 – 110_C (18 – 230_F)
D Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool and run engine
at idle speed for 10 sec. or more.
3) Then run engine over 3000 rpm for 10 sec. or more.
4) Check DTC and pending DTC.
TROUBLESHOOTING
STEP
1
Was "ENGINE DIAG. FLOW TABLE" performed?
2
1) Remove ECM (PCM) cover referring to "Voltage
Check" in this section.
2) Start engine and check voltage between E228-29
and E228-30 terminals.
Engine speed at 3000 rpm: about 3.1 V
Engine speed at idling: about 2 V
Is each value satisfied?
NOTE:
If DTC is checked using generic scan tool only and DTC P0100 (P0100) Diag. Flow Table is not performed
yet, go to the table before ECM replacement.
ACTION
YES
Go to Step 2.
Intermittent trouble or
faulty ECM.
Check for intermittent
referring to
"Intermittent and Poor
Connection" in
Section 0A.
(See NOTE.)
NO
Go to "ENGINE DIAG.
FLOW TABLE".
Clogged or leaky air
intake system.
If all are OK, substitute
a known-good MAF
sensor and recheck.
Chapters
Table of Contents
