Table of Contents
5.3. Reassembly
IF ANY OF THE RF, BLUETOOTH OR BASEBAND SHIELDS ARE REMOVED FROM THE PCB AT ANY TIME, THEY
MUST BE REPLACED BY NEW ITEMS. ONCE REMOVED, THE SHIELDS MUST NOT BE REUSED.
NOTES:
IIf the case assemblies have been disassembled and reassembled more than three times, they should be
replaced with new items.
Examine all case and cover parts before reassembly. If any scratches or defects are found in their finish,
they should be replaced by new items.
5.3.1. Upper Housing Reassembly
To be advised.
5.3.2. Upper Cover Reassembly
1. Upper cover reassembly includes the upper cover with following: 1) lower camera gasket, camera and 2) receiver holder,
receiver cushion, receiver and magnet.
5.3.3. Upper Flex PCB Reassembly
1. Upper flex PCB reassembly includes the following: main LCD assembly which includes the main LCD, main LCD bezel,
main LCD adhesive, main LCD gasket and four conductive cushions. Sub LCD reassembly which includes the sub LCD frame
and handsfree assembly. Ensure that all the components are securely attached and that all connectors are fully and properly
seated.
2. Have the hinge pivot ready to complete the upper flex PCB reassembly. Carefully slide the flexible portion of the upper flex
into the hinge pivot with the closed side of the hinge pivot facing away from the upper cover. When tilting the PCB, take
care not to damage the camera or flex. Carefully slide the upper flex PCB and hinge pivot together so that the flex stays
in the slot of the upper cover while it is inserted into the upper cover.
PROVISIONAL ISSUE
CAUTION
– 5-11 –
Table of Contents
