Table of Contents
Install all DIMMs ("DIMMs" on page 53).
13.
Install all DIMM baffles
14.
Install the internal USB drive.
15.
Install the storage controller or connect the direct connect SATA cable
16.
cabling" on page 80).
Install the FlexibleLOM ("FlexibleLOM" on page 49).
17.
Install the mezzanine assembly
18.
Install the drives ("Drive" on page 33).
19.
Install the drive blanks
20.
Install the access panel.
21.
Install the graphics server blade.
22.
After you replace the system board, you must re-enter the graphics server blade serial number and the
product ID.
During the graphics server blade startup sequence, press the F9 key to access UEFI System
1.
Utilities.
Select the System Configuration > BIOS/Platform Configuration (RBSU) > Advanced Options
2.
> Advanced System ROM Options > Serial Number, and then press the Enter key.
Enter the serial number and press the Enter key. The following message appears:
3.
The serial number should only be modified by qualified service
personnel. This value should always match the serial number located on
the chassis.
Press the Enter key to clear the warning.
4.
Enter the serial number and press the Enter key.
5.
Select Product ID. The following warning appears:
6.
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
Enter the product ID and press the Enter key.
7.
Press the F10 key to confirm exiting System Utilities. The graphics server blade automatically
8.
reboots.
Server blade release lever assembly
To remove the component:
Power down the graphics server blade (on page 25).
1.
Remove the graphics server blade
2.
Remove the access panel
3.
Remove all drives ("Drive" on page 33).
4.
Remove all drive blanks
5.
Remove the mezzanine assembly
6.
Do one of the following:
7.
Remove the storage controller
o
Disconnect the direct connect SATA cable
o
Remove the internal USB drive, if installed. To locate the internal USB connector, see "System
8.
board components (on page 91)."
Remove all DIMM baffles
9.
("DIMM
baffles" on page 51).
("Mezzanine
assembly" on page 34).
("Drive
blank" on page 32).
("Remove the graphics
("Access panel (graphics server
("Drive
blank" on page 32).
("Mezzanine
("Storage
controller" on page 50)
("Direct connect SATA
("DIMM
baffles" on page 51).
("Direct connect SATA
blade" on page 26).
blade)" on page 31).
assembly" on page 34).
cabling" on page 80).
Removal and replacement procedures 68
- Quick Links:
- Graphics Server Blade Components
Hide quick links:
Table of Contents
