Panasonic BL-WV10A Operating Instructions Manual page 145
Wireless camera monitoring system
Hide thumbs
Also See for BL-WV10A:
- Setup manual (20 pages) ,
- Setup manual (14 pages) ,
- Service manual (56 pages)
Table of Contents
Error Message
Sequential Display mode
is active.
Set mode switch on back
of unit to [NORMAL], then
turn unit off/on.
SD Memory Card Error Messages
Error Message
SD Memory Card is
locked.
Unlock the SD Memory
Card and try again.
No SD Memory Card.
Insert card and try again.
SD Memory Card is full.
Cannot use this SD
Memory Card.
Could not format.
[For assistance, please call: 1-800-272-7033]
Causes and Solutions
This error is displayed when the remote control is
used during Automatic Display Mode.
•
Set the mode switch on the back of the device
to Normal and turn the power on again.
Causes and Solutions
This error is displayed when an SD memory
card's write-protection is on.
•
Turn the write-protection off.
This error appears if an SD memory card has not
been inserted.
•
Insert an SD memory card.
This error is displayed if there is no free space on
the SD memory card.
•
Insert a blank SD memory card, or erase
unneeded data from it.
This error appears when an SD memory card not
recognized by the BL-WV10A is used.
•
Use a recognizable SD memory card or
format it using the BL-WV10A (see
page 120).
This error appeals when memory card formatting
fails.
•
Re-format the card. If that fails to correct the
problem, use a different SD memory card.
15 Error Messages
145
Table of Contents
