Table of Contents
Note Although it exists in the PXM20, this command is not needed within
Siemens
Building Technologies
11.2
The Wink command
In certain cases where third-party integration is involved, the PXM20
may need to be specifically identified for commissioning purposes.
the DESIGO system.
The identification process is carried out with the Wink command.
Figure 11-5 The "Wink" command
To send the Wink command, select Send service pin message.
This immediately triggers the Wink signal.
Figure 11-6
PXM20 / PXM20-E operator unit
Service support
61/70
CM110754en_02
17 Dec 2009
- Quick Links:
- Ip Settings (Pxm20-E Only)
- Login
- Password
Hide quick links:
Table of Contents
