Snmp Operation Configuration Example - HP 5920 Configuration Manual
Hide thumbs
Also See for 5920:
- Command reference manual (607 pages) ,
- Configuration manual (424 pages) ,
- Fc and fcoe configuration manual (257 pages)
Table of Contents
SNMP operation configuration example
Network requirements
As shown in
from the SNMP agent.
Figure 47 Network diagram
Configuration procedure
1.
Assign each interface an IP address. (Details not shown.)
2.
Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
3.
Configure the SNMP agent (Device B):
# Enable the SNMP agent, and set the SNMP version to all, the read community to public, and the
write community to private.
[DeviceB] snmp-agent sys-info version all
[DeviceB] snmp-agent community read public
[DeviceB] snmp-agent community write private
4.
Configure Device A:
# Create an SNMP operation, and configure 10.2.2.2 as the destination IP address.
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type snmp
[DeviceA-nqa-admin-test1-snmp] destination ip 10.2.2.2
# Enable the saving of history records.
[DeviceA-nqa-admin-test1-snmp] history-record enable
[DeviceA-nqa-admin-test1-snmp] quit
# Start the SNMP operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# After the SNMP operation runs for a period of time, stop the operation.
[DeviceA] undo nqa schedule admin test1
# Display the most recent results of the SNMP operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Send operation times: 1
Min/Max/Average round trip time: 50/50/50
Square-Sum of round trip time: 2500
Last succeeded probe time: 2011-11-22 10:24:41.1
Extended results:
Packet loss ratio: 0%
Figure
47, configure an SNMP operation to test the time the NQA client uses to get a value
Receive response times: 1
156
- Quick Links:
- Configuring Snmp
Hide quick links:
Table of Contents
