Fuel Gauge; Trip Meter / Clock / Voltmeter - Yamaha 115C Owner's Manual
Hide thumbs
Also See for 115C:
- Owner's manual (124 pages) ,
- Owner's manual (229 pages) ,
- Service manual (21 pages)
Table of Contents
Instruments and indicators
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26713
Fuel gauge
Eight segments indicate the fuel level. When
all segments are showing, the fuel tank is
full.
The fuel level reading can be inaccurate due
to the position of the sensor in the fuel tank
and the attitude of the boat in the water. Op-
eration with bow-up trim or continuous turn-
ing can give false readings.
Do not adjust the selector switch for fuel sen-
sor. Incorrectly setting the selector switch on
the gauge will give false readings. Consult
your Yamaha dealer on how to correctly set
the selector switch. NOTICE: Running out
of fuel can damage the engine.
22
EMU36071
Trip meter / Clock / Voltmeter
The display shows either the trip meter, the
clock, or the voltmeter.
To change the display, press the "
(mode) button repeatedly until the indicator
on the face of the gauge points to "
meter), "
EMU26691
Trip meter
This gauge displays the distance the boat
has traveled since the gauge was last reset.
The trip distance is shown in kilometers or
miles depending upon the unit of measure-
ment selected for the speedometer.
To reset the trip meter to zero, press the "
(set) and "
time.
The trip distance is kept in memory by bat-
tery power. The stored data will be lost if the
battery is disconnected.
ZMU01745
EMU26701
Clock
To set the clock:
1.
Be sure the gauge is in the "
mode.
2.
Press the "
play will begin blinking.
3.
Press the "
desired hour is displayed.
[ECM01770]
4.
Press the "
minute display will begin blinking.
" (clock), or "
" (voltmeter).
" (mode) buttons at the same
" (set) button; the hour dis-
" (mode) button until the
" (set) button again, the
"
" (trip
"
" (time)
Table of Contents
