Table of Contents
ADJUSTMENTS & SETTINGS (MAIN MENU)
2
2
5 Repeat steps 2
2
2 to 4
Skip 2 if you do not change the cursor position.
•
•
Only one comment can be stored regardless of the program number you chose in
SAVE PRG. Same comment will be stored in PRG. 1 through PRG.3. Different
comments cannot be stored in each program.
•
When printing in FIELD mode, the comment is a little lower in quality.
MEMORY POSITION Memory and Position setting
•
The print area settings made with this menu can be memorized as a user program
setting.
LINE
Selects whether a frame of print area is shown or not.
OFF
A frame of print area is not shown.
ON
A frame of print area is shown.
•
When LINE is set to ON, the monitor colour may be changed, or the image may become
unstable horizontally depending on the H-POSI setting. In this case, set LINE to OFF.
•
When the frame becomes over the setting area, the frame colour turns black.
•
The frame is not displayed on the memory image.
H-POSI
Changes the horizontal start position of input signal.
The whole data image can be moved horizontally by changing the setting
number.
Setting area -8 - +8
•
When setting minus value too large, the right side of the memory image is clipped on
the monitor. However, it is printed normally.
V-POSI
Changes the vertical start position of input signal.
The whole data image can be moved vertically by changing the setting
number.
Setting area -10 - +0
36
4
4
4 to complete a comment.
4
MEMORY POSITION
LINE
OFF/ON
H-POSI
0
V-POSI
0
LINE
H-POSI
+
V-POSI
+
Table of Contents
