Table of Contents
5. When the desired wait time is flashing press
Set for 2300 and 1400 formats that require Acknowledgements on Even Rounds:
1. Follow the procedures in Section 5.4.2.
2
2. Press
for pulse format menu.
3. Press
until the display flashes on the Ack/ Even field.
4. Select the format by pressing the
5. When the desired wait time is flashing press
Set for 3/1 and 4/1 Partially Extended Formats:
1. Follow the procedures in Section 5.4.2.
2
2. Press
for pulse format menu.
3. Press
until the display flashes on the Partially Ex field.
4. Select the format by pressing the
5. When the desired wait time is flashing press
5.4.2.3
Line Options
Line options is used to set the type of phone line,
number of rings, country, and threshold voltage.
Note: Setting the number of rings to 0 disables
the line device.
How to Set the Line Card for a Direct Line (Dedicated Line):
Note: This option must only be chosen for panels that have a direct connect capability. The panel supplies all
line bias and a PBX is not required. This options sets the line card for a dedicated mode where the line is
dedicated to the panel and normal timeouts will not occur.
1. Follow the procedures in Section 5.4.2.
3
2. Press
for Line Options menu.
3. The display will flash on the Direct field.
4. Press the
or
5. When the desired setting is flashing press
ENTER
MENU
or
ENTER
MENU
or
ENTER
MENU
button to between Y for Yes, or N for No.
ENTER
MENU
or
.
button.
or
.
button.
or
.
3=Line Options
4 Listen In
5 Misc. Line Opt.
Direct=N Rings=002
Country=USA
Thresh=08 Sample=08
Figure 5–15: MX8000–LC3 Line Options Menu
or
.
Section 5 – Programming
¯
5–37
Table of Contents
Troubleshooting
