Removing Hinge From Front Panel; Removing Door Lock From Front Panel - Electrolux EIGD55H Technical & Service Manual
Wave-touch & iq-touch
front-load dryer
Hide thumbs
Also See for EIGD55H:
- Technical & service manual (100 pages) ,
- Installation instructions manual (24 pages) ,
- Specifications (2 pages)
Table of Contents
Installation Information
Removing Hinge from Front
Panel
1. With the hinge in open position, remove 2 short,
course-thread, panhead screws on hinge plate.
(See Figure 2-21)
2. Remove 3 short, fine-thread, counter-sunk screws in
hinge side. (See Figure 2-22)
3. Slide the hinge toward the center of the front panel,
and then pivot the hinge inward while slowly pulling
it away from the front panel to expose the attached
harness.
4. Lift up on the tab and the release harness from the
retainer, allowing the harness to lay outside the front
panel. (See Figure 2-23)
Figure 2-21.
Figure 2-22.
Figure 2-23.
Removing Door Lock from Front
Panel
1. Remove 2 short, course-thread, panhead
screws from the door lock. (See Figure 2-24)
2. Slide the lock toward the outer edge of the
front panel. Pivot the lock slightly outward
while slowly pulling it through opening to
expose the attached harness.
(See Figure 2-25)
3. Release the harness from the terminal with
the small lever on back of the lock. Separate
the harness from the lock, allowing the harness to
lay outside the front panel. (See Figure 2-26)
2-16
Figure 2-24.
Figure 2-25.
Figure 2-26.
Hide quick links:
Table of Contents
