Programming - Panasonic Aquarea WH-MDF06E3E5 series Installation Manual
Aquarea air/water heat pump – heating and cooling systems
Hide thumbs
Also See for Aquarea WH-MDF06E3E5 series:
- Installation manual (90 pages) ,
- Design handbook (132 pages) ,
- Operating instructions manual (36 pages)
Table of Contents
8.2 Programming
Note
As the same operator control
panel is used for different
devices, some functions may
not apply for your device.
Displays
Operation LED
1
Display of external room
2
thermostat
Display of solar installation
3
Display of operation of additional
4
electric heater for heat pump
and emergency heating mode
(ON / OFF)
Display for quiet mode
5
(ON / OFF)
Hot-water tank operation
6
display (ON / OFF)
Cooling operation display (ON /
7
OFF) (The operator control
panel of the SDF models has
no display for cooling mode)
Heating operation display
8
(ON / OFF)
Display of timer setting and time
9
Display of outside temperature
10
Display of water outlet
11
temperature
Display of additional electric
12
heater for the heat pump and
the electric immersion heater
for the hot-water tank
(ON / OFF)
Display for defrosting (ON / OFF)
13
Display for system program-
14
ming (ON / OFF)
Display for system status
15
(ON / OFF)
Display for service (ON / OFF)
16
Aquarea air/water heat pump – Installation manual for compact systems 03 / 2013
8
7
6
HEAT
COOL
5
TANK
QUIET
4
HEATER
FORCE
3
OPERATION
2
1
TIMER
OFF/ON
CLOCK
26
Button assignment
Operation button (ON / OFF)
17
Operating mode selection button
18
Use this button to select the operating
mode required.
System status buttons
19
These buttons are used for a series of
status queries. Proceed as follows:
Press the CHECK button for 5 seconds
to switch to Status mode.
Press the UP or DOWN button to open
the following values:
1. Compressor operating frequency
2. Error code
3. Water inlet temperature
4. Water tank temperature
Press the CANCEL button or wait
30 seconds to quit Status mode.
Service button
20
This button takes you to menu items Sr:01
for pump down mode and Sr:02 for
circulation pump. You can toggle
between the two menu items using
the SEARCH arrow buttons.
Display | Button assignment
9
10
11
TIMER
OUTDOOR
ACTUAL
HEATER
BOOSTER
DEFROST
SETTING
STATUS
SERVICE
WATER OUTLET
OFF/ON
SETTING
STATUS
SET
MODE
CHECK
SEARCH
SELECT
QUIET
HEATER
ERROR
CANCEL
RESET
FORCE
SERVICE
25 24
23
22
21 20
Button for enabling the additional elec-
21
tric heater for the heat pump. The addition-
al electric heater can only be user if this
button is pushed. Note: If this button is not
pressed, the additional electric heater for
the heat pump is only used for:
Defrosting
Device startup
Frost protection mode
Emergency heating mode button
22
This button allows the device to be operated
in emergency heating mode with the
additional electric heater for the heat
pump, e.g. if the heat pump is defective.
Press the ON / OFF button to switch off
emergency heating mode.
Error reset button
23
Quiet mode button
24
System programming buttons
25
These buttons are used to set temperature
values.
Timer programming buttons
26
These buttons are used to set the time and
the weekly timer.
Commissioning
Programming
12
13
14
15
16
17
18
19
8 – 37
8
Hide quick links:
Table of Contents
