Ipv6 Enable - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
44
IPv6 Router Commands
See the definition of the ipv6 route command for details.
Example
:
The following example configures a default gateway
console(config)# ipv6 default-gateway fe80::abcd%vlan1
44.6
ipv6 enable
Use the ipv6 enable command in Interface Configuration mode to enable IPv6
processing on an interface.
Use the no form of this command to disable IPv6 processing on an interface that
has not been configured with an explicit IPv6 address.
Syntax
ipv6 enable
no ipv6 enable
Parameters
N/A.
Default Configuration
IPv6 addressing is disabled.
Command Mode
Interface Configuration
User Guidelines
This command automatically configures an IPv6 link-local Unicast address on the
interface while also enabling the interface for IPv6 processing. The no ipv6 enable
command does not disable IPv6 processing on an interface that is configured with
an explicit IPv6 address.
Example
The following example enables VLAN 1 for the IPv6 addressing mode.
interface vlan 1
ipv6 enable
730
78-21075-01 Command Line Interface Reference Guide
Table of Contents
