11.4 Auto Calibration setup
1. Connect as Fig 13.4.1(RS232 serial cable is connected between COM port of PC and MON port of TEST JIG,
in general. GPIB-USB-HS cable is connected between HP8960 and PC.)
2. Set the Power Supply 5.3V
3. Set the 3
rd
, 4
th
of DIP SW ON state always
4. Press the Phone power key, if the Remote ON is used, 1
Copyright © 2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Figure 13.4.1 Equipment setup
st
ON state
150/158
- 159 -
11. AUTO CALIBRATION
13. AUTO CALIBRATION
5.300 V 0.000A
LGE Internal Use Only