Nat - D-Link DSL-2740U User Manual

Section 3 – Web Configuration

NAT ALG

Choose ADVANCED > NAT > NAT ALG. The page shown in the figure appears

on the right. Choose the NAT ALG and Pass-Through options, and then click

Apply Changes.

NAT Exclude IP

Choose ADVANCED > NAT > NAT Exclude IP. The page shown in the figure

appears on the right. In the page, you can configure some source IP addresses

which use the purge route mode when accessing internet through the specified

interface.

NAT Forwarding

Choose ADVANCED > NAT > NAT Forwarding. The page shown in the figure

appears on the right. Under 1483MER or 1483Routed mode, if NAPT (Network

Address Port Translation) is enabled, the Local IP Address is configured as

192.168.1.3 and the Remote IP Address is configured as 202.32.0.2, the PC with

the LAN IP192.168.1.3 will use 202.32.0.2 when it is connected to the Internet via

the router without NAPT control.

The following table describes the parameters and buttons of this page:

Field

Local IP Address

Remote IP Address Input a remote IP address

Enable

D-Link DSL-2740U User Manual

Description

Input a local IP address.

Enable the current configured rule.

65