Table of Contents
Installation
Instructions
[STEP 191 CONNECT WATER SUPPLY
I
',
Refrigerator
House
//
_W(]ter
Supplg
Water Suppl,/
-_ .....
................
-
_ oo-J'/
, Locate and bring the tubing to the front of the cabinet,
, Turn the water
on to flush debris from the line, Run
about a quart of water through
the tubing into a
bucket, then shut off the water,
Copper
Tubing:
, Slip a 1/4" nut and ferrule (provided) over both ends of
the copper tubing, Insert the tube into the union fitting
on the unit and tighten
the nut to the union,
, Turn on the water to check for leaks,
GE SmartConnect
TM Tubing:
NOTE: The only OE-approved
plastic tubing is supplied
in the GE SmartConnect
TM Refrigerator
Tubing kits, Do
not use any other plastic water supply line because
the line is under pressure at all times, Other types of
plastic may crack or rupture with age and cause water
damage
to your home,
GE SmartConnect TM Refrigerator Tubing Kits are
available in the following lengths:
2' (,6 m)
WXOSXlO002
8'(2,4 m)
WXOSX10006
15' (4,6 m) WXO8X1 0015
25' (7,6 m) WXOSX10025
, Insert the molded end of the tubing into the
refrigerator
connection,
Tighten the compression
nut
until it is just hand tight,
, Tighten one additional
turn with a wrench,
Overtightening
can cause leaks!
, Turn on the water to check for leaks,
NOTE: Make sure excess tubing length does not
interfere
with the toekick installation,
[STEP 20 CONNECT POWER, CLOSE
GRILLE PANEL
, Open the grill panel,
, Plug in the power cord (if necessary) by reaching
into
the opening
next to the water filter, If access is too
tight, remove the 2 screws holding the water filter
bracket and move aside, Plug in the power cord and
secure the bracket with the original screws,
\
Master Light
Electrical
Switches
Outlet Access
, Check to make sure power to refrigerator
is on by
opening
refrigerator
door to see if interior
lights are
on,
, The temperature
controls
are preset at 37°F for the
fresh food section and O°F for the freezer,
, Allow 24 hours to stabilize before making
adjustments,
ISTEP 211 START ICEMAKER
/cernc_ker
/
/
Power
Switch
Fee/er Arm
, Slide the switch to ON, The icemaker
will begin
operation
automatically,
, Be sure nothing
interferes
with the sweep of the feeler
arm,
, Discard the first full bucket of ice cubes,
, To turn the icemaker
off, slide the switch to OFF,
26
Hide quick links:
Table of Contents
