Before You Call For Service - GE Monogram 27" Owner's Manual

Convection wall oven

Hide thumbs Also See for Monogram 27":

Owner's manual (45 pages)

Use and care manual (32 pages)

Installation instructions manual (12 pages)

Table Of Contents

page of 44

/ 44
Contents
Table of Contents

Table of Contents

Trouble-

shooting tips

PROBLEM

OVEN DOOR WILL

NOT OPEN AFTER

A CLEAN CYCLE

OVEN NOT

CLEAN AFTER

A CLEAN CYCLE

"LOCK"

FLASHES IN

THE DISPLAY

LOCKED LIGHT

IS ON WHEN

YOU WANT TO COOK

CONTROL SIGNALS

AFTER ENTERING

COOKING TIME OR

DELAY START

"F—AND A NUMBER

OR LETTER" FLASH

IN THE DISPLAY

DISPLAY GOES

BLANK

DISPLAY FLASHES

UNABLE TO GET

THE DISPLAY TO

SHOW "SF"

"PROBE" APPEARS

IN THE DISPLAY

POWER OUTAGE,

CLOCK FLASHES

STEAM FROM

THE VENT

"BURNING" OR

"OILY" ODOR

EMITTING FROM

THE VENT

STRONG ODOR

FAN NOISE

POSSIBLE CAUSE

• The oven is too hot. Allow the oven to cool below locking

temperature.

• Oven controls improperly set. See the Using the Self-Cleaning Oven

section.

• Oven was heavily soiled. Clean up heavy spillovers before starting the

clean cycle. Heavily soiled ovens may need to self-clean again or for a

longer period of time.

• The self-clean cycle has been selected but the door is not closed.

Close the oven door.

• The oven door is locked because the temperature inside the oven has

not dropped below the locking temperature. Press the CLEAR/OFF

pad. Allow the oven to cool.

• You forgot to enter a bake temperature or cleaning time. Press the

BAKE pad and desired temperature or the SELF CLEAN pad and

desired clean time.

• You have a function error code. Press the CLEAR/OFF pad. Allow

the oven to cool for one hour. Put the oven back into operation.

• Disconnect all power to the oven for 30 seconds and then reconnect

power. If the function error code repeats, call for service.

• A fuse in your home may be blown or the circuit breaker tripped.

Replace the fuse or reset the circuit breaker.

• The clock is in the black-out mode. See the Oven Control, Clock and

Timer section.

• Power failure. Reset the clock.

• Oven control pads were not pressed properly. The BAKE and the

BROIL HI/LO pads must be pressed at the same time and held

for 3 seconds.

• This is reminding you to enter a probe temperature after plugging

in the probe. Enter a probe temperature.

• Power outage or surge. Reset the the clock. If the oven was in use,

you must reset it by pressing the CLEAR/OFF pad, setting the clock

and resetting any cooking function.

• When using the convection feature, it is normal to see steam coming

out of the oven vent. As the number of shelves or amount of food

being cooked increases, the amount of visible steam will increase.

• This is normal in a new oven and will disappear in time. To speed

the process, set a self-clean cycle for a minimum of 3 hours. See the

Using the Self-Cleaning Oven section.

• This is temporary. An odor from the insulation around the inside of

the oven is normal for the first few times the oven is used.

• A cooling fan or a convection fan (depending on the function

you are using) may automatically turn on and off. This is normal.

The cooling fan will turn off and on. The convection fan will run

until the function is over or the door is opened.