Replacing The Secondary Hard Disk Drive - Lenovo ThinkCentre M93/p User Manual
Hide thumbs
Also See for ThinkCentre M93/p:
- Safety, warranty, and setup manual (2 pages) ,
- Hardware maintenance manual (308 pages) ,
- User manual (180 pages)
Table of Contents
Replacing the secondary hard disk drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the secondary hard disk drive.
To replace the secondary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 42.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 42.
4. Press the retaining clip
same time.
Figure 81. Pivoting the drive bay assembly upward
5. Locate the secondary hard disk drive bay. See "Locating internal drives" on page 16.
6. Disconnect the signal cable and the power cable from the primary hard disk drive and secondary
hard disk drive.
1
in the direction as shown and pivot the drive bay assembly upward at the
.
Chapter 5
Installing or replacing hardware
85
Hide quick links:
Table of Contents
Troubleshooting
