Table of Contents
4.
Adjustment
4-1.
FWD Position Adjustment
Perform this adjustment after the tension regulator ass'y and the S-reel table ass'y are replaced or removed.
• TG1 FWD position adjustment
• FWD back tension adjustment (Refer to Page 6-108).
1)
Enter the R/P mode and confirm the positions of TG1 guide and the TG2 guide.
• Confirm that the distance between the flanges on the TG1 guide and the TG2 guide is 2 mm by inserting the block gauge or the pin
gauge between them to measure. If the distance is not 2 mm, perform the following adjustment.
2)
Loosen the screw and adjust the band adjuster so that the distance between the flanges on the TG1 guide and the TG2 guide becomes 2
mm using the adjustment screwdriver (Ref. No. J-7), and finally tighten the screw.
Tightening torque: 0.06 ± 0.01 N•m (0.61 ± 0.1 kgf•cm)
Note: When measuring the distance between guides by inserting the block gauge or pin gauge, be very careful not to damage the roller.
TG1 guide
Band adjuster
Fixing screw
HVR-A1J/A1U/A1N/A1E/A1P/A1C
TG2 guide
Adjustment
screwdriver
Band adjuster
TG1 nut
Flange on the TG1
TG1 nut
Flange on the TG1
2mm
Fig. 6-2-4
6-105
2mm
TG2 nut
Flange on the TG1
Block gauge,
pin gauge, etc
TG2 nut
Flange on the TG1
- Quick Links:
- Specifications
- Table of Contents
Hide quick links:
Chapters
Table of Contents
