Cisco SPA 525G2 Administration Manual page 127
Hide thumbs
Also See for SPA 525G2:
- Administration manual (298 pages) ,
- User manual (95 pages) ,
- Quick start manual (2 pages)
Table of Contents
Configuring SIP, SPCP, and NAT
Network Address Translation (NAT) and Cisco IP Phones
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 10
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide
Make sure you do not have firewall running on your PC that could block the syslog
port (by default this is 514).
Log in to the configuration utility. For information about this, see the
Web-Based Configuration Utility" section on page
Click Admin Login > Advanced. (For WIP310, click Admin Login.)
Click the System tab, then set
your syslog server. Note that this address and port number has to be reachable
from the Cisco IP phone. This port number appears on the output file name. The
default port number is 514. The default output is named syslog.514.log (if port
number was not specified).
Debug Level
Set
to 3. Do not change the value of the
To capture SIP signaling messages, click the Ext tab.
SIP Debug Option
Set
To collect information about what type of NAT your router uses click the SIP tab
and scroll to NAT Support Parameters.
SIP
Back in the
tab, select yes in the
View the debug messages to determine if your network uses symmetric NAT. Look
for the Warning header in REGISTER messages, for example, Warning: 399 Spa
"Full Cone NAT detected."
Click Submit All Changes.
Debug Server
to Full.
STUN Test Enable
12.
to the IP address and port number of
Syslog Server
drop-down box.
4
"Using the
parameter.
115
Hide quick links:
Table of Contents
