Ipv6 Pim Rp-Address - Dell Networking 2024 Reference Manual
Hide thumbs
Also See for Networking 2024:
- System information manual (273 pages) ,
- User manual (46 pages) ,
- System information manual (33 pages)
Table of Contents
Default Configuration
The default threshold rate is 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim register-threshold 250
ipv6 pim rp-address
Use the ipv6 pim rp-address command to statically configure the RP address
for one or more multicast groups. The optional keyword override indicates
that if there is a conflict, the RP configured with this command prevails over
the RP learned by BSR. Use the no form of this command to remove the RP
address for one or more multicast groups.
Syntax
ipv6 pim rp-address
no ipv6 pim rp-address
rp-address — An RP address.
•
group-address —The group address to display.
•
prefixlength —This parameter specifies the prefix length of the IP address
•
for the media gateway. (Range: 1–32)
Default Configuration
There are no static RP addresses configured by default.
Command Mode
Global Configuration mode
1174
IPv6 Multicast Commands
rp-address group-address/prefixlength
[ override ]
Chapters
Table of Contents
