Brother DCP-145C User Manual page 78
Copier printer
Hide thumbs
Also See for DCP-145C:
- User manual (108 pages) ,
- Quick setup manual (2 pages) ,
- Service manual (529 pages)
Table of Contents
d
Turn the green knob on the protective
yellow cap clockwise until it clicks as to
release the seal vacuum, then remove
the cap (1).
e
Each colour has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Gently push the ink cartridge until it
clicks, and then close the ink cartridge
cover.
70
Downloaded from ManualsPrinter.com Manuals
1
g
The machine will automatically reset the
ink dot counter.
Note
• If you replaced an ink cartridge, for
example Black, the LCD may ask you to
verify that it was a brand new one
(Did You Change Blck?). For each
new cartridge you installed, press a (Yes)
to automatically reset the ink dot counter
for that colour. If the ink cartridge you
installed is not a brand new one, be sure
to press b (No).
• If the LCD shows No Cartridge or
Cannot Detect after you install the ink
cartridge, check that the ink cartridges are
installed correctly.
WARNING
If ink gets in your eyes, wash them out with
water at once and call a doctor if you are
concerned.
CAUTION
DO NOT take out ink cartridges if you do
not need to replace them. If you do so, it
may reduce the ink quantity and the
machine will not know the quantity of ink left
in the cartridge.
DO NOT touch the cartridge insertion slots.
If you do so, the ink may stain your skin.
If ink gets on your skin or clothing
immediately wash it off with soap or
detergent.
If you mix the colours by installing an ink
cartridge in the wrong position, clean the
print head several times after correcting the
cartridge installation.
Hide quick links:
Table of Contents
