Table of Contents
Black level (master pedestal) adjustment
The black level can be adjusted when using a multiple number of
cameras including the unit. Ask your dealer to perform this adjustment.
(Use an oscilloscope or waveform monitor for the adjustment.)
Adjust the black level in accordance with the units and devices used.
When performing operations from a wireless
remote control
1.
Press the button.
Set the iris to the manual mode.
2.
Press the button.
The lens iris is stopped down.
3.
Press the <4> or <5> button to bring the cursor to
[Picture].
4.
Press the button.
The [Picture 1/3] sub-menu is displayed.
P i c t u r e 1 / 3
Chr o m a L e v e l
Whi t e B a l a n c e M o d e
Co l o r T e m p e r a t u r e
R G a i n
B G a i n
Ped e s t a l
R P e d e s t a l
B P e d e s t a l
Ret u r n
5.
Press the <4> or <5> button to bring the cursor to
[Pedestal].
P i c t u r e 1 / 3
Chr o m a L e v e l
Whi t e B a l a n c e M o d e
Co l o r T e m p e r a t u r e
R G a i n
B G a i n
Ped e s t a l
R P e d e s t a l
B P e d e s t a l
Ret u r n
6.
Press the button to start the "Pedestal" value
blinking.
7.
Press the <4> or <5> button, change the [Pedestal]
value, and press the button to enter the selection.
Adjust the value so that it matches the black level.
The pedestal values can be adjusted finely using the [R Pedestal] and
[B Pedestal] settings. (→ page @@)
8.
Press and hold the
The camera menu display is exited.
9.
If necessary, press the [A/IRIS] button to adjust the iris
automatically.
When performing operations from a controller
When using a AW-RP50, AW-RP120, or AK-HRP200
Refer to the operating instructions for the controller.
0 %
A W B A
3 2 0 0 K
0
0
1 6
0
0
0 %
A W B A
3 2 0 0 K
0
0
1 6
0
0
35
- Quick Links:
- Network Settings
- Troubleshooting
Hide quick links:
Table of Contents
